Step 1: 

Take apart your pod system. Most open case frameworks comprise two segments: the case cartridge and the unit mod. On the off chance that your pack has more discrete parts, dismantle those also.

Cleaning the Zero Vape Connections

We want to start by cleaning the connections.  Where your case mod associates with your case cartridge must be cleaned routinely, as messy associations will meddle with your mod’s capacity to send capacity to the curl.

Step 2: 

Take a cotton ball with some rubbing alcohol in it.  Then, gently but thoroughly wipe down the connections on both the battery and the cartridge.

Step 3:

Next, utilize your q-tip to clean the associations that interface the mod to your charging gadget. Grimy associations will meddle with your battery’s capacity to charge appropriately.

Cleaning the Renovo Zero Base

Presently, we should clean the case of your case mod. Flotsam and jetsam can make the catches in the long run become stuck, which implies the finish of your unit mod.

Step 4: 

In the event that your unit mod has catches, check to ensure that the border of those catches is away from garbage. On the off chance that it’s not, take a stab at utilizing a toothpick or another little, sharp item to deliberately remove flotsam and jetsam. 

Step 5: 

Whenever you’ve dealt with the catches, you can give your unit mod a brisk wipe-down utilizing a microfiber material that has been dunked into simply a smidgen of water or scouring liquor.

Cleaning the pod cartridge

Once you’re done cleaning the mod now you can move onto the pod cartridge. 

Step 6: 

Start by emptying your pod cartridge. Try to clear out as much as you can.

Step 7: 

Fill it with warm water, give it a brisk shake, and dump it out. This will get out any garbage extra from the last e-fluid.

Cleaning the mouthpiece

Step 8:

On the off chance that your case framework has a different mouthpiece or trickle tip, eliminate that and run tepid water through it. Presently, look inside. In the event that you can see flotsam and jetsam or juice gunk, take a cotton swab or toothpick and carefully dislodge what’s inside.

After all the above process you can refill your pod and can start to vape.

Leave a Reply

Your email address will not be published. Required fields are marked *